2012 Nissan Navara

Nearside Front Tyre worn close to legal limit/worn on edge 2.6mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge 2.7mm (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn smooth on inner edge (5.2.3 (e))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge 2.9mm (5.2.3 (e))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive Rear hub seal, has slight leak. (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Tyre worn close to legal limit/worn on edge 2.6mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge 2.7mm (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn smooth on inner edge (5.2.3 (e))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge 2.9mm (5.2.3 (e))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive Rear hub seal, has slight leak. (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Horn not working (7.7 (a))

Offside Front Lower Suspension arm ball joint excessively worn bottom ball joint (5.3.4 (a) (i))

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Horn not working (7.7 (a))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

Exhaust has a minor leak of exhaust gases front flexi (6.1.2 (a))

Suspension arm ball joint has slight play both front lower (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Rearward of Spring Shackle (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Front Side repeater with a multiple light source up to 1/2 not functioning (4.4.1 (a) (i))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive Shock Absorber Mounting (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge Worn on Both Edges (5.2.3 (e))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive Rearward of Spring Shackle (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive Shock Absorber Mounting (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)