2013 Fiat 500C

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive sump (8.4.1 (a) (i))

rear axle surface corroded

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Central Front Exhaust mounting defective (6.1.2 (a))

Front Drl,s Inoperative.

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing Tyre At 2.5 mm. (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge Inner Edge Void of Tread! (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases from rear (6.1.2 (a))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm worn on the inner shoulder (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm Worn on the inner shoulder (5.2.3 (e)) DANGEROUS