1990 Nissan Micra

Nearside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Body has slight corrosion (6.1.B.2)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Rear Body has slight corrosion (6.1.B.2)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front registration plate deteriorated (6.3.1d)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust has been repaired not blowing at time off test

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake discs scored

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear coil spring worn (2.4.C.1b)

Oil leak from engine

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear bump stops perished

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Stop lamp not working (1.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear brake discs scored

Rear bump stops perished

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

car been standing

car been standing

Offside Front Seat belt insecurely fixed to the seat (5.2.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)