1989 Rover Mini

Nearside Front Play in steering rack inner joint(s) ()

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Macpherson strut ball joint has slight play (5.3.4 (a) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced boot floor (6.1.1 (c) (i))

Front Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced boot floor (6.1.1 (c) (i))

Oil leak ()

Exhaust emissions carbon monoxide content excessive 9.22 (7.3.B.1a)

Nearside Direction indicators flashing less than 60 times a minute not flashing (1.4.A.2g)

Nearside Direction indicators not working (1.4.A.2c)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor pan (2.4.A.3)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded floor pan (2.4.A.3)

Rear Body has a sharp edge caused by corrosion bumper by fog light (6.1.C.1)

Oil leak ()

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

o.s.f wheel bearing feel's slightly rough when rotated

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning lamps inoperative (1.4.B.1b)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Rear fog lamp not working (1.3.2b)