1990 Land Rover Defender

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Seat belt webbing slightly damaged or frayed (7.1.2 (b))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Seat belt webbing slightly damaged or frayed (7.1.2 (b))

Wheel/tyre protruding beyond wheel arch ()

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Seat belt webbing slightly damaged or frayed (7.1.2 (b))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Seat belt webbing slightly damaged or frayed (7.1.2 (b))

Wheel/tyre protruding beyond wheel arch ()

Electrical wiring inadequately secured under bonnet (4.11 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Outer Seat belt webbing slightly damaged or frayed both (7.1.2 (b) (ii))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Front Tyre fouling a part of the vehicle both (5.2.3 (f))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

split pin missing from rear top joint

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Shock absorbers insecurely attached (5.3.2 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn spanner arm bushes (5.3.4 (a) (i))

Nearside Rear Halfshaft securing bolt loose (6.1.7 (a) (i))

Offside Front Suspension rod insecurely attached nut loose (5.3.3 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Steering wheel rim loose (2.2.1 (c) (i))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

split pin missing from rear top joint

tracking out

Exhaust noisy (8.1.1 (a))

Front Lower Shock absorbers has a slightly worn bush both (5.3.2 (c))

Nearside Rear hub bolt loose

Central Exhaust system insecure (6.1.2 (a))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch inoperative (4.5.3 (a) (ii))

Exhaust noisy (8.1.1 (a))

Front Lower Shock absorbers has a slightly worn bush both (5.3.2 (c))

Nearside Rear hub bolt loose

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Axle swivel joint has slight movement between a swivel joint and its housing (2.5.A.1b)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Offside Headlamp damaged but light output not reduced (1.7.5a)

Nearside Front Torque/reaction arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Offside Torque/reaction arm has excessive play in a pin/bush (2.4.G.2)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

corrosion signs starting on outer casing on n/s/r/chassis section area

corrosion starting on rear cross beam area

Nearside Rear Wheel nut(s) loose (4.2.A.1e) DANGEROUS

corrosion signs starting on outer casing on n/s/r/chassis section area

corrosion starting on rear cross beam area

Nearside Front Service brake grabbing slightly (3.7.C.2)