2013 Mercedes-benz Sprinter

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Play in steering rack inner joint(s)

Offside Rear half shaft seal leaking

Nearside Rear Anti-roll bar pin or bush excessively worn lower bush (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Play in steering rack inner joint(s)

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement lower bush (5.3.4 (a) (i))

Offside Rear half shaft seal leaking

Front Exhaust system insecure (6.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front wheel bearing has slight play Both (2.5.A.3c)

Offside Rear Tyre worn close to the legal limit On 2.45 MM (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Body has a sharp edge caused by damage Side repeater (6.1.C.1)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D-Bush (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively Both Front (8.2.2)

Front wheel bearing has slight play Both (2.5.A.3c)

Offside Rear Tyre worn close to the legal limit On 2.45 MM (4.1.E.1)