1990 Saab 900

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor/jacking point (6.2.2 (d) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security boot floor (6.2.2 (d) (i))

rear exhaust box is slightly blowing

Nearside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Rear Direction indicator lens defective such that the emitted light is adversely affected (4.4.1 (b) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength door sill (5.3.6 (a) (i))

rear exhaust box is slightly blowing

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Coil spring mounting corroded and seriously weakened (2.4.C.3c)

Offside Front constant velocity joint is excessively worn (2.5.C.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Shock absorber has a slightly worn bush (2.7.4)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front Shock absorber has a slightly worn bush (2.7.4)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

poor fitting cv gaiter fiited to o/s/front

Oil leak

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

n/s front bumper end cap secured with tape

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Front registration plate deteriorated (6.3.1d)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

n/s front bumper end cap secured with tape

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front registration plate deteriorated (6.3.1d)

Offside Front Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake lever has no reserve travel (3.1.6b)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)