1989 Austin Mini Mayfair

Brake pedal wearing smooth (1.1.2 (c))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake pedal wearing smooth (1.1.2 (c))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Brake pedal wearing smooth (1.1.2 (c))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Exhaust noisy (8.1.1 (a))

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Nearside Play in steering rack inner joint(s)

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Front Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Nearside Play in steering rack inner joint(s)

Exhaust emits dense blue smoke at idle (7.3.A.2b)

Exhaust emits excessive dense blue smoke during acceleration (7.3.A.2c)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

underside corroded sills covered with graphics stickers!

Bonnet cannot be secured in the closed position (8.4.1)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Upper Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Headlamp insecure (1.7.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Brake pipe slightly corroded (3.6.B.2c)

extensive areas of vehicle structure heavy in surface corrosion, efficient at time of test.

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

extensive areas of vehicle structure heavy in surface corrosion, efficient at time of test.

n/s rear boot floor 1st stages of corrosion, efficient at time of test.

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

h brake u/bal, sill and arch trims, boot floor corr and repaired, fuel cap seal minor, multi repairs to sills and floors, f panel corroded, f ball joints play, repairs sealed multi

Front registration plate missing (6.3.1a)

Horn not working (1.6.2a)

Nearside Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear brake application uneven (3.7.B.2)

Centre Exhaust mounting missing (7.1.1b)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Indicator tell tale inoperative (1.4.A.2a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is fractured (2.4.A.3)

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Steering rack gaiter split (2.2.D.2d)

Sub-frame attachment bracket/mounting insecure (2.4.G.1)

rear brake application uneven (3.7.B.2)

main beam warn inop, sill guards os and ns and corrosion at os and ns, ns boot floor repaired, fuel cap seal det, nsf body corroded, arches loose, oil leak, inner cv boots leaking grease.

nsf floor ex corroded non pa, all floors corroded cat used, osr back plate corroded, r tyres minor det.

osr inner arch corroded, minor wear to 4x front ball joints, dips poor image, rad det, nsf inner wing corroded, top arm bushes nsf det.

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

both outer sills,front panel,both floors and underside of vehicle in a rusty condition

n/s/f tyrewall cracking

Exhaust has a major leak of exhaust gases (7.1.2)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Horn not working (1.6.2a)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

both outer sills,front panel,both floors and underside of vehicle in a rusty condition

n/s/f tyrewall cracking

Front Exhaust system not adequately supported (7.1.1)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Shock absorber insecure (2.7.2b)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)