1990 Toyota MR2

Brake lever has insufficient reserve travel (1.1.2 (a))

Exhaust emissions likely to be affected by an induction leak leak at manifold not affecting emissions but requires attention (8.2.1.1 (b))

Nearside Front Brake performance not tested binding brake (1.2.1 (g))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill corroded (6.1.1 (c) (i))

Offside Front Brake insecure backplate severely corroded liable to fall off (1.1.21 (c))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Shock absorbers has a serious fluid leak (5.3.2 (b))

Central Rear Brake pipe corroded, covered in grease or other material pipe to brake valve (1.1.11 (c))

Central Rear Fuel Pipe/s corroded ()

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced plate welded but not continuous (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced wheel arch corroded (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded repair imminent (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive underside (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Horn not working (7.7 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength trailing armarea (5.3.6 (a) (i))

Offside Front Macpherson strut ball joint excessively worn (5.3.4 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor area corrosion (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking brake lever worn, but not excessively hand brake travel (1.1.6 (b) (i))

Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

surface rust to underside

Offside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Parking brake lever has little reserve travel (3.1.6b)

n/s mirror insecure

surface corrision to underside

Bonnet retaining device ineffective (8.4.2)

Nearside Front Brake hose inappropriately repaired (3.6.A.3)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Brake hose inappropriately repaired (3.6.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Suspension arm has slight play in a pin/bearing (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension arm has slight play in a pin/bearing (2.4.G.2)

Offside Front Macpherson strut is slightly stiff in the upper support bearing assembly (2.5.B.1b)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Macpherson strut is slightly stiff in the upper support bearing assembly (2.5.B.1b)