1990 Rover Mini

Driver's seat insecure (6.2.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Rear Exhaust system not adequately supported (7.1.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake pads are thin and will very soon need replacing

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Direction indicators flashing more than 120 times a minute (1.4.A.2g)

Exhaust engine idle speed too high (7.3.A.2a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate dirty (6.3.1d)

Front registration plate insecure (6.3.1b)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Headlamp aim too low and too far to the left. (1.8)

Oil leak

bodywork surface rust offside rear by wheel arch drivers door offside front a frame & by both headlights

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear fog lamp not working (1.3.2b)

Steering column top bearing excessively worn (2.1.2c)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Steering column retaining device insecure (2.1.6)

Bonnet cannot be secured in the closed position (8.4.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Seat belt retracting mechanism defective (5.2.5b)

Offside Rear fog lamp not working (1.3.2b)

Horn not working (1.6.2a) DANGEROUS

engine oil level low