1990 Rover Mini

Exhaust has a minor leak of exhaust gases Centre To Rear Join (6.1.2 (a))

Fuel hose perished

Horn not working properly (7.7 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Has been welded, an area has not had a constant seam weld but will not effect the overall vehicle structure

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

oil leak evident

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Exhaust has a minor leak of exhaust gases Centre To Rear Join (6.1.2 (a))

Fuel hose perished

Horn not working properly (7.7 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Has been welded, an area has not had a constant seam weld but will not effect the overall vehicle structure

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

oil leak evident

Water leak

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust engine idle speed too high (7.3.A.2a)

Nearside Outer Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Wheel nut(s) loose (4.2.A.1e)

Offside Headlamp aim too high and too far to the right. (1.8)

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Bolt loose on radiator

Water leak

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

engine oil leak

Centre Registration plate lamp not working (1.1.C.1d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

engine oil leak

n/s/f top suspension arm has play in bearing

n/s/f tyre worn on edge

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust system not adequately supported (7.1.1)

Indicator switch insecure (1.4.A.1)

Nearside Front Suspension arm attachment bracket/mounting insecure (2.4.G.1)

rear brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

n/s/f top suspension arm has play in bearing

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a part missing (7.1.1a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

topped up engine oil

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Outer Front Lower Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside Steering rack gaiter split (2.2.D.2d)

Rear Sub-frame corroded and seriously weakened (2.4.G.1) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

top engine stabiliser has excessive play

Nearside Front Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Front Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a) DANGEROUS

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Obligatory mirror missing (8.1.1)

small exhaust leak

Body insecure and dangerous to other road users (6.1.B.1b)

Direction indicators not working (1.4.A.2c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust system not adequately supported (7.1.1)

Indicator tell tale inoperative (1.4.A.2a)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Front wheel bearing has excessive play (2.5.A.3c)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Rear Shock absorber has negligible damping effect (2.7.5)

Rear fog lamp tell tale not working (1.3.1b)

Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

small exhaust leak

corrosion to drivers door and panel.

corrosion to rear subframe .

slight freeplay to upper and lower balljoints nearside.