1989 Fiat Panda

suspension rubber`s perished

Offside Headlamp aim too high (4.1.2 (a))

suspension rubber`s perished

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Integral body structure is modified but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Emissions not tested due to coolant leak (8.2.1.2 (d))

Fuel pipe insecure rubbing on coil (6.1.3 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Seat belt not functioning as intended (7.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Coolant leak radiator

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Coolant leak radiator leaking

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Coolant leak radiator leaking

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm locating pin locking device not properly locked (2.4.G.3b)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)