1989 Citroen C15

Brake pedal anti-slip provision missing (1.1.2 (c))

Nearside Front Headlamp aim too high adjuster worn (4.1.2 (a))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis leg wing (6.1.1 (c) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor pan (6.2.2 (d) (i))

Offside Front Headlamp aim too high adjuster worn (4.1.2 (a))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Offside Fuel hose leaking (6.1.3 (b) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Sub-frame corroded but not seriously weakened front and rear (5.3.3 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

rear exhaust rubber missing...

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake load sensing valve linkage defective and function impaired spring loose (1.1.17 (a))

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Offside Front on body signs of fiber glass and underseald

signs of fiberglass on outer sill

some welding carried out from inside

underside and inner arches heavily undersealed also signs of fibre glass on outer sills

Brake pedal anti-slip provision missing (3.3.A.1b)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Headlamp aim too high (1.8)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

some welding carried out from inside

underside and inner arches heavily undersealed also signs of fibre glass on outer sills

passenger side windscreen cracked

Brakes imbalanced across an axle (3.7.B.5b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

passenger side windscreen cracked

Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Centre Rear Lower Fuel system component insecure (7.2.1) DANGEROUS

Brakes imbalanced across an axle (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) DANGEROUS

Direction indicators not working (1.4.A.2c)

Front Windscreen wiper control missing (8.2.1a)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear cross member has been welded

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

exstensive welding to rear cross member.

n/s and o/s floors around seat belt anchorages have been welded.