2011 Nissan 300 Zx

Rear Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pad(s) wearing thin 4.0 mm` left on (1.1.13 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Upper Coolant leak very small ()

Offside Rear Brake pad(s) wearing thin 4.0 mm` (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust catalytic converter obviously modified nearside front and offside front lambda sensors missing engine been tuned modified removal of catalyst emission control both sides (8.2.1.1 (a))

Exhaust emissions likely to be affected by an exhaust leak centre exhaust joints leaking gases (8.2.1.1 (b))

Nearside Front Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Position lamp light intensity significantly reduced side light faulty led bulb flickering (4.2.3 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively wiper blade torn (3.4 (b) (ii))

Offside Front Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Offside Front Position lamp not working side light not working (4.2.1 (a) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively wiper blade torn (3.4 (b) (ii))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

advise engine burning oil from rear exhausts

advise steering rack mounting rubbers becoming weak and movement in steering rack but not excessive when loaded recommend rubber mounting replacement