1989 Austin Mini Thirty

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor corroded around old bung (5.3.6 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Outer outer lower front wing by door corroded

Nearside Front upper inner arch by A pillar corroded

Nearside Front valance brake corroded inner front wing

Offside Rear Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

all passenger seat belts not checked

front and rear bumpers not fitted

no passenger seats fitted

o/s/ and n/s sills covered in underseal not allowing full inspection.

plastic wheel arch covers not fitted

Emissions not tested (8.2.1.2 (d))

Front Brake pedal anti-slip provision missing (1.1.2 (c))

Hazard warning lamps inoperative (4.4.1 (e))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower valance (5.3.6 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded buckhead / chassis corroded right hand side from engine bay. (1.1.21 (e) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower valance (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe corroded, covered in grease or other material all covered in under seal (1.1.11 (c))

Nearside Front inner arch repair covered in under seal

Nearside Front inner sill/floor corroded

Nearside Front upper inner arch bulkhead where A pillar joins corroded.

Offside Front floor corroded by bung

front grill and both bumpers missing

sills and under body covered in under seal not allowing full inspection.

spare wheel well corroded small hole

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pipe slightly corroded (3.6.B.2c)

Brake cable has wires broken and is significantly weakened (3.5.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Exhaust system not adequately supported (7.1.1)

Registration plate lamp not working (1.1.5c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment bracket/mounting insecure (2.4.G.1)

Offside Front Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen wiper blade insecure (8.2.2)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Offside Body has slight corrosion (6.1.B.2)

Offside Body has slight corrosion (6.1.B.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake application uneven (3.7.B.2)

Brake pipe slightly corroded (3.6.B.2c)

coolant leaking