1990 Rover Maestro

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material slight (1.1.11 (c))

Offside Front Shock absorbers has light misting of oil slight (5.3.2 (b))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive engine oil (8.4.1 (a) (i))

Hazard warning lamps inoperative (4.4.1 (e))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive engine oil (8.4.1 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake hydraulic reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Drive shaft joint constant velocity boot severely deteriorated slighty worn (6.1.7 (g) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

slight under body corrosion

Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cross member (6.1.B.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cross member (6.1.B.2)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension component mounting prescribed area is excessively corroded sill-floor (2.4.A.3)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded sill-floor (2.4.A.3)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive x member (2.4.A.3)

Offside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Coil spring mounting corroded and seriously weakened (2.4.C.3c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)