1989 Vauxhall Nova

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Wheel bearing has slight play offside and nearside (5.1.3 (a) (i))

Rear Wheel bearing slightly noisy offside and nearside (5.1.3 (b) (i))

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Front position lamp(s) incorrect colour (1.1.A.3e)

Horn not loud enough to be heard by another road user (1.6.2b)

Nearside Headlamp aim too high (1.8)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Tyre fouling a part of the vehicle fouling strut (4.1.D.2)

Offside Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

windscreen cracked

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Parking brake lever has little reserve travel (3.1.6b)

nearside headlamp dips to offside(mask fitted)

nearside rear wheel bearing slightly rough

note filler noted in strut top areas

Emissions not tested (7.0)

Offside Front Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

note ++ engine overheated buring BETS test but was failing on lambda (low) and CO (high)

note filler noted in strut top areas

Both front slightly cracked & perished

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

Play in steering rack inner joint(s)

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Front Steering system lightly rubbing (2.2.D.2a)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Play in steering rack inner joint(s)

advise front wiper conversion/ passenger side view

front bumbper slightly insecure

front number plate slightly insecure

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Service brake application uneven across the axle (3.7.D.2b)

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Front Steering system lightly rubbing (2.2.D.2a)

Front bumper insecure

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

advise front wiper conversion/ passenger side view

front number plate slightly insecure

slight play in steering rack inner joints

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front passenger door cannot be opened from outside the vehicle (6.2.B.1b)

Nearside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Side repeater missing (1.4.A.2b)

Offside Front Headlamp aim too high (1.8)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Service brake application uneven across the axle (3.7.D.2b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Side repeater missing (1.4.A.2b)

Rear reflector missing (1.5.1a)

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Front Steering system lightly rubbing (2.2.D.2a)

Front bumper insecure

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

front number plate slightly insecure

nearside front tyre slightly perished/ cut inner sidewall

nearside rear tyre slightly perished round tread

slight play in steering rack inner joints

Nearside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Steering system lightly rubbing (2.2.D.2a)

sill covers fitted

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too high (1.8)

Nearside Side repeater insecure (1.4.A.2b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Side repeater insecure (1.4.A.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Steering system lightly rubbing (2.2.D.2a)

sill covers fitted

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front registration plate character(s) likely to be misread (6.3.4b)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Side repeater missing (1.4.A.2b)

Nearside Rear wheel bearing has excessive play (2.6.2)

Offside Front Headlamp aim too high (1.8)

Offside Front Side repeater missing (1.4.A.2b)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside rear brake binding (3.7.B.1)

Service brake juddering severely (3.7.C.2)

Service brake: efficiency below requirements (3.7.C.1a)

Battery insecure

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside inner sill has been modified but has not reduces the original strength