2002 Mitsubishi Colt

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced both sides (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Central Rear Stop lamp not working (1.2.1b)

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Stop lamp not working (1.2.1b)

Front Anti-roll bar has slight play in a pin/bush both sides (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Rear Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

engine management light stays on

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Upper Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Upper Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

engine management light stays on

front side lights worked when tapped and stay on during test

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

corrosion on chassis

Offside Front Front position lamp(s) not working (1.1.A.3b)