2008 Ford Ka

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing perishing (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mount (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing perishing (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Headlamp aim not tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Rear Brake pipe corroded, covered in grease or other material Greased (1.1.11 (c))

Offside Rear position lamp(s) not working Rear (1.1.A.3b)

Nearside rear tyre badly cracked and deteriorated!

Offside rear outer sill slightly corroded

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

advise both rear tyres showing cracks in tread and sidewalls

advise offside front,nearside rear tyres wearing/worn inner outer edges

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)