2002 Mitsubishi Fto

Brake performance unable to be tested due to chassis corrosion (1.2.1 (g))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) DANGEROUS

Offside Rear Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) DANGEROUS

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

repairs undersealed

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear cross section (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor pan (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear cross section (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle underside corroded % heavily undersealed

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

brake pipes coated in underseal

Front Headlamp has a product on the lens but not seriously reducing light output Both (1.7.5a)

Lower Body has slight corrosion Under side - repaired areas coated in paint/under-seal. (6.1.B.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Rear Service brake just passed attention recommended.

Rear registration plate deteriorated but not likely to be misread cracked (6.3.1d)

Suspension arm corroded but not seriously weakened All (2.4.G.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Floor and Sill adjacent trailing arm mounting (6.1.B.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Floor/sill adjacent trailing arm mounting (6.1.B.2)

Offside Rear rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Lower Body has slight corrosion Throughout some area's have been repaired painted / re- under-sealed in past. (6.1.B.2)

Lower Suspension arm corroded but not seriously weakened throughout (2.4.G.1)

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Vehicle structure has slight corrosion (6.1.B.2)

Rear registration plate deteriorated but not likely to be misread cracked (6.3.1d)

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both front coil springs

both rear tyres wearing on inner edges

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Parking brake lever has no reserve travel (3.1.6b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Body has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Body has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Vehicle structure has slight corrosion (6.1.A.1)

Body has slight corrosion (6.1.B.2)

Vehicle structure has slight corrosion (6.1.A.1)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Steering rack gaiter split (2.2.D.2d)