2008 Fiat Panda

all four coil spring corroding

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

all four coil springs corroding

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Oil leak, but not excessive gearbox end plate (8.4.1 (a) (i))

Oil leak, but not excessive sump pan (8.4.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Oil leak, but not excessive gearbox end plate (8.4.1 (a) (i))

Oil leak, but not excessive gearbox end plate (8.4.1 (a) (i))

Oil leak, but not excessive sump pan (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust system insecure (6.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Nail in tyre ()

Oil leak, but not excessive drive shaft oil seal (8.4.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Service brake lagging in operation (1.2.1 (d))

Nearside Rear Nail in tyre ()

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Oil leak, but not excessive drive shaft oil seal (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Oil leak, but not excessive driveshaft seal (8.4.1 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Oil leak, but not excessive driveshaft seal (8.4.1 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Nail in tyre ()

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Valve stem slightly damaged rubber stem deteriorating (4.1.D.1e)

Offside Rear Valve stem slightly damaged rubber stem deteriorated (4.1.D.1e)

Offside Rear tyre worn/wearing on inner edge

exhaust rear silencer outer skin deteriorating/corrosion

rear view mirror deteriorating

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Rear tyre worn/wearing on inner edge

Offside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Rear exhaust silencer outer skin deteriorated/corrosion

Rear registration plate deteriorated but not likely to be misread cracked (6.3.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

advise - rear exhaust silencer outer skin deteriorated/corrosion

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

advise - exhaust rear silencer and clamp deteriorating/corrosion

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Wheel bolt(s) missing (4.2.A.1e)

exhaust back box outer skim seperating

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

exhaust back box outer skim seperating

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)