2008 Ford Ka

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim not tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn rear most bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn rear most bush (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm pin or bush worn but not resulting in excessive movement Both front (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both front (5.3.4 (a) (i))

Foot brake just met the brake limit

Integral body structure is corroded but structural rigidity is not significantly reduced underneath corroded (6.1.1 (c) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security underneath corroded (6.2.2 (d) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

all vehicle structure corroded underneath corroded

Body has slight corrosion both side sills (6.1.B.2)

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)