2010 Audi A5

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake excessively binding (1.2.1 (f))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Central Exhaust system insecure (6.1.2 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)