2010 Jaguar Xf

Brake hose has slight corrosion to ferrule all front and rear (1.1.12 (f) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre on 3mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge wearing on edges (5.2.3 (e))

Offside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Front Windscreen washer not working (3.5 (a))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords multiple cuts to cord (5.2.3 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre on 3mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge wearing on edges (5.2.3 (e))

Offside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security BOTH SIDES (6.2.2 (d) (i))

Windscreen washer not working (3.5 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Lower Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Lower Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security BOTH SIDES (6.2.2 (d) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced rear sub frame and mountings corroded inareas unreachable with corrosion assesment tool (6.1.1 (c) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced rear sub frame and mountings corroded inareas unreachable with corrosion assesment tool (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))