2002 Piaggio Vespa

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Brake cable insecure (1.1.15 (c))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Forks excessively deformed (2.2.2 (d) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Suspension component pin or bush excessively worn lower engine/suspension mounts (5.3.4 (a) (i))

Riders seat insecure (6.2.5 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases exhaust not tested> wont start (6.1.2 (a))

Wheel alignment slightly misaligned bars out of alignment with wheel (2.4 (a))

front mudgaurd damaged leaving sharp edges

battery not secure/incorrectly fitted

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Lower Brake caliper inadequately mounted caliper securing bolt (1.1.16 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Headlamp aim too low (4.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Steering headbearing excessively stiff or notchy Very stiff - hard to steer (2.2.2 (f) (i))

Exhaust downpipe slightly loose - rusted around front screw

Front Wheel bearing has slight play (5.1.3 (a) (i))

Centre Front Headlamp aim too low (1.6)

Centre Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Riders seat insecure (6.2.1a)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i)) DANGEROUS

Indicator switch defective (1.5.4)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))