2005 Fiat Scudo

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner and outer sill (6.1.1 (c) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp lens slightly defective poor beam image (4.1.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Stop lamp(s) non-obligatory stop lamp not working High level (4.3.1 (a) (ii))

Integral body structure is repaired but structural rigidity is not significantly reduced several patches throughout underside/inner sills of vehicle, all inspected and adequatley repaired (6.1.1 (d) (i))

Offside Front Anti-lock braking system warning lamp indicates an ABS fault abs ring broken (1.6 (b))

Tyre tread depth below requirements of 1.6mm all four tyres are at legal limit and below (5.2.3 (e)) DANGEROUS

Offside Front Radius arm has slight play in a pin/bush Rear Bush (2.4.G.2)

Offside Front Radius arm has slight play in a pin/bush Rear Bush (2.4.G.2)

Offside Headlamp aim too high (1.8)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim too high (1.8)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)