2013 Mercedes-benz C

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Brake performance unable to be tested (1.2.1 (g))

Nearside Rear Brake pipe leaking on an air braking system (1.1.11 (b) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin inner pads (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material Close to excessive (1.1.11 (c))

Parking brake has travel adjustment advisible

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Driver's airbag obviously inoperative (7.1.5 (c))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

o/s/r parking brake force lower than the n/s

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)