2002 Suzuki GZ125

Drive chain sprocket carrier worn to excess (6.2.1e)

Front brake binding slightly but not affecting efficiency on rolling brake test

Gear shift operating lever worn and not fully tight on gear shift shaft

Exhaust is leaking and excessively noisey Blowing badly at cylinder head joint (7.1.1b)

Front Stop lamp remains on when the brake is released (1.3.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp aim too low (1.6)

Registration plate insecure (6.3.1b)

Nearside Footrest insecure Riders foorest mount securing bolt sheared off (6.2.1a) DANGEROUS

Rear Exhaust mounting missing Rear muffler mount point spacer missing (7.1.1c) DANGEROUS

Front brake binding slightly but not affecting efficiency on rolling brake test

Gear shift operating lever worn and not fully tight on gear shift shaft

Rear Tyre valve stem slightly misaligned Rear wheel inner tube stem locknut not secured (4.1.2c)

Rear brake cable sticking slightly but not causing binding

Nearside hadlebar unit requires securing

Throttle unit end damaged, requires end caps on both ends of handlebars

Drive chain slightly tight (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Drive chain sprocket slightly worn (6.2.1e)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))