2006 Peugeot 107

Emissions not tested not tested due to condition of exhaust system (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases exhaust mainifold to cylinder head joint badly corroded and leaking gases (6.1.2 (a))

Nearside Indicator switch inoperative indicator switch does not work to the nearside (4.4.2 (a) (ii))

Rear Exhaust has a major leak of exhaust gases centre to rear exhaust joint (6.1.2 (a))

Rear Exhaust system insecure centre to rear sections (6.1.2 (a))

Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush bonding breaking up (5.3.4 (a) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 2.0mm & worn on edges (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge 2.5mm & worn on edges (5.2.3 (e))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Road wheel fractured at bridge over valve (5.2.2 (a))

Offside Rear Road wheel fractured at bridge over valve (5.2.2 (a))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Road wheel fractured at bridge over valve (5.2.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Road wheel fractured at bridge over valve (5.2.2 (a))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Central Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp not working on dipped beam (1.7.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front bumper insecure

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Front bumper insecure

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Spare tyre defective

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)