2005 Kia Sorento

Nearside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axel tie bar mounting (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill panel corroded (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axel tie bar mounting (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm outer edge , primary (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Rear Suspension component mounting repair covered in underseal cross chassis tube (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axel mounting / tie bar (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Registration plate lamp not working both (1.1.C.1d)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)