2008 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both drop link (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both chassis (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Headlamp lens seriously defective both (4.1.1 (b) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Headlamp aim too far to the right both (4.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front pads and discs worn

Offside Rear Service brake excessively binding (1.2.1 (f))

Front pads and discs worn

Nearside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

both n/s/tyres getting low

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

both n/s/tyres getting low

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

front discs corroded

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front discs corroded

Nearside Headlamp aim too low (1.8)