2004 Honda CG125

Registration plate deteriorated but not likely to be misread (0.1 (b))

Drive chain slightly loose (6.1.7 (c) (i))

Front Wheel spoke slightly corroded (5.2.2 (d))

Rear Wheel spoke slightly corroded (5.2.2 (d))

Wheel alignment slightly misaligned (2.4 (a))

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Nearside Rear Drive chain worn to excess (6.2.1e)

Nearside Rear Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Nearside Rear Drive chain sprocket slightly worn (6.2.1e)

Front wheel bearings are tight but not considered excessive (2.3.5b)

Center stand not fully retracting

Front wheel bearings are tight but not considered excessive (2.3.5b)

Rear Registration plate delaminated (6.3.1.d)

Center stand not fully retracting

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Drive chain worn to excess (6.2.1e)

Front Brake lever has inadequate reserve travel (3.1.3b)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Handlebar deformed (2.1.1b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Headlamp aim too low (1.6)

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear reflector on motorcycle missing (1.4.1)

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)