MOT Status
ExpiredMileage
178,656 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Offside Front Shock absorbers has a slightly worn bush top mount (5.3.2 (c))
Oil leak, but not excessive (8.4.1 (a) (i))
Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))
all rear suspension corroded
Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Offside Front Shock absorbers has light misting of oil (5.3.2 (b))
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Rear Coil spring corroded (5.3.1 (b) (i))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Rear Coil spring corroded (5.3.1 (b) (i))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Rear Brakes imbalanced across an axle (1.2.1 (b) (i))
Nearside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Rear Coil spring corroded (5.3.1 (b) (i))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Rear Coil spring corroded (5.3.1 (b) (i))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Front Shock absorbers has a reduced damping effect (5.3.2 (d))
Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))
Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Tyre worn close to legal limit/worn on edge 1.83mm (5.2.3 (e))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Tyre worn close to legal limit/worn on edge 2.10 (5.2.3 (e))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))
Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))
Reversing lamp switch does not operate automatically when reverse gear is selected (4.6.3 (a))
Front Shock absorbers has a reduced damping effect (5.3.2 (d))
Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))
Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Tyre worn close to legal limit/worn on edge 1.83mm (5.2.3 (e))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Tyre worn close to legal limit/worn on edge 2.10 (5.2.3 (e))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
parking brake efficiency low,17%
Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))
Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Nail in tyre ()
Offside Front Front wheel bearing rough when rotated (2.5.A.2)
Offside Rear Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)
Nearside Rear Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Nearside Rear Seat belt flexible stalk damaged likely to lead to failure under load middle row n/s (5.2.4a)
Nearside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)
Offside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)
Offside Registration plate lamp not working (1.1.C.1d)
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)
Exhaust has a minor leak of exhaust gases (7.1.2)
Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Front registration plate deteriorated but not likely to be misread (6.3.1d)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Direction indicators incorrect colour (1.4.A.2f)
Nearside Rear Registration plate lamp not working (1.1.C.1d)
Offside Rear Direction indicators incorrect colour (1.4.A.2f)
Front registration plate deteriorated but not likely to be misread (6.3.1d)
Nearside Rear Brake pad(s) wearing thin (3.5.1g)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Ford S-max?
Based on 1,368,227 MOT tests across 101,843 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
GM10 SAN is a 2010 Ford S-max in Grey with a 1,997cc diesel engine. This vehicle has been through 19 MOT tests with a personal pass rate of 68.4%.
Across all 2010 Ford S-max models, the average MOT pass rate is 74.2% with a typical mileage of 83,408 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Ford S-max fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 26,089 recorded failures. If you're considering buying GM10 SAN, it's worth having these areas checked by a mechanic before committing.
The Ford S-max typically stays on UK roads for around 20 years. At 16 years old, this Ford S-max is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of GM10 SAN?
You can check the full history of GM10 SAN by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was GM10 SAN registered?
GM10 SAN is a 2010 Ford S-max, first registered on 18 March 2010.
Is GM10 SAN safe to buy?
The MOT history for GM10 SAN shows 19 tests with a 68.4% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does GM10 SAN have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on GM10 SAN. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.