2009 Yamaha Wr 125 R

Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Footrest missing (6.2.12 (a))

Front Brake pad(s) close to minimum limit front pads near legal limit 1mm (1.1.13 (a))

Rear Lower Rear suspension bush has excessive free play (2.4.A2a(i))

Front Clutch lever bent Clutch lever worn to excess (6.2.1g)

Front Headlamp aim too low (1.6)

Front Steering headbearing has slight free play (2.2.2)

Rear Drive chain slightly loose (6.2.1d)

Rear Drive chain worn but not considered excessive (6.2.1e)

Rear Exhaust noisy (7.1.2)

Rear Rear reflector on motorcycle missing (1.4.1)

Front Brake disc(s) is slightly distorted (3.2.A1m)

Front Floor brake test indicates a slightly grabbing brake (3.3.C2d)

small oil leak n/s engine

Horn not working (1.7.3a)

Handlebar deformed (2.1.1b)

Drive chain sprocket worn to excess both front and rear (6.2.1e)

Drive chain worn to excess (6.2.1e)

Front Brake pad(s) contaminated by oil or grease (3.2.A1k)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords sidewalls cracked/perished (4.1.2a(i))

Front Wheel spoke excessively loose (4.2.1b)

Nearside Front Front shock absorber seal failed and leaking oil (2.3.3)

Rear suspension bush has excessive free play lower shock pivot (2.4.A2a(i))

Rear suspension bush has excessive free play side play in swing arm (2.4.A2a(i))

Nearside Front Front suspension assembly excessive wear or free play in a front suspension component fork internals loose9rattling) (2.3.4) DANGEROUS

Nearside Front Handlebar handgrip not secure to handlebars. (2.1.1c) DANGEROUS

Front Brake disc(s) is slightly distorted (3.2.A1m)

Front Floor brake test indicates a slightly grabbing brake (3.3.C2d)

small oil leak n/s engine

Offside Front Fairings insecure but not likely to impede the steering (2.1.2e)

excess oil on chain starting to go on tyre side wall

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))