2002 Fiat Ducato

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Central Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced in 3 places (6.1.1 (c) (i))

Emissions unable to be completed exhaust condition (8.2.2.2 (e))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength out rigger (5.3.6 (a) (i))

Nearside Front Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength at rear (5.3.6 (a) (i))

Offside Front Brake hose excessively chafed both (1.1.12 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength out rigger (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is inadequately repaired inner arch (5.3.6 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength at front and rear (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer not working both (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

underside of vehicle covered in underseal

Brake pipe corroded, covered in grease or other material all other pipes covered in grease/ slightly corroeded (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened BOTH (1.1.14 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front bonnet hinge

Central Front Brake pipe excessively corroded marked with yellow chalk (1.1.11 (c))

Horn not working (7.7 (a))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Rear Outline marker lamp not working (4.2.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Brake pipe corroded, covered in grease or other material all other pipes covered in grease/ slightly corroeded (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened BOTH (1.1.14 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front bonnet hinge

Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner and outer sill (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner chassis (6.2.2 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced 4 sided (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner and outer sill (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner chassis (6.2.2 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Horn not working (1.6.2a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Subframe mounting prescribed area is excessively corroded near jacking point (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded chassis (2.4.A.3)

Offside Side repeater not working (1.4.A.2c)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Brake pipe slightly corroded front to rear (3.6.B.2c)

Central corrosion to chassis non prescribed area

Offside Front tyre has slight cracks to tread

welding repairs heavily undersealed unable to full inspect

Front Seat belt anchorage prescribed area is corroded but not considered excessive both sides inner sills (5.2.6)

Front Suspension spring mounting prescribed area is corroded but not considered excessive both sides (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Offside Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

slight corrosion on o/s chassie

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

slight plaY BOTH front wheel bearings

Front Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS