2008 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Seat belt buckle not functioning as intended wont clip in (7.1.2 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault flashing (7.1.6 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front tyre wearing both edges

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

interior mirror deteriorated

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emits black smoke during acceleration (7.3.A.2c)

Nearside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Rear wheel bearing rough when rotated (2.6.1)

Rear Exhaust system not adequately supported (7.1.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

EML on

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too low (1.8)

EML on

engine managment light on

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

engine managment light on

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)