2010 Toyota Prius

Nearside Rear Hydraulic brake calliper leaking Build-up Of Brake Fluid Dripping From Brake Calliper (1.1.16 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Has A Large Hole (5.3.6 (a) (i))

Offside Rear Hydraulic brake calliper leaking Build-up Of Brake Fluid Dripping From Brake Calliper (1.1.16 (b) (i))

Offside Rear Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Has A Large Hole (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Vehicle Underbody/Brake Pipes Covered In Underseal

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

brake pipes have protective coatings

engine, under and sill covers fitted

slight play in steering rack

Headlamp aim projected beam image is obviously incorrect ns (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

both front tyres wearing on edges

brake pipes have protective coatings

engine, under and sill covers fitted

ns and os front lower arm rear bushes deteriorating

rear brake discs wearing

slight play in steering rack

unable to check rear pads properly

engine , under and sill cover sfitted

slight play in ns steering rack

Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt nsf (5.3.4 (b) (ii))

Brake lever has insufficient reserve travel (1.1.2 (a))

Headlamp aim projected beam image is obviously incorrect nsf (4.1.2 (c))

Headlamp not working on dipped beam os (4.1.1 (a) (ii))

Wheel bearing has excessive play osr (5.1.3 (a) (i))

Tyre tread depth below requirements of 1.6mm osf (5.2.3 (e)) DANGEROUS

engine , under and sill cover sfitted

slight play in ns steering rack

slight play in ns track rod end

brakepipes have protective coatings

Headlamp aim too low osf (4.1.2 (a))

Tyre tread depth below requirements of 1.6mm both front (5.2.3 (e)) DANGEROUS

brakepipes have protective coatings

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)