2001 Toyota Yaris

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Anti-roll bar pin or bush excessively worn Both (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Sill (5.3.6 (a) (ii)) DANGEROUS

Central Rear Registration plate lamp insecure NUBER PLATE ILLUMINATION LAMP,INSECURE, WORKING OK. (4.7.1 (c) (i))

N/S/R FOOT AND HANDBRAKE EFFORT POOR, JUST MEET REQUIREMENTS.

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim not tested IMAGE INCORRECT. (4.1.2 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp aim too low VERY LOW. (4.1.2 (a))

Offside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Central Rear Registration plate lamp insecure NUBER PLATE ILLUMINATION LAMP,INSECURE, WORKING OK. (4.7.1 (c) (i))

N/S/R FOOT AND HANDBRAKE EFFORT POOR, JUST MEET REQUIREMENTS.

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Central Headlamp not working on dipped beam (4.1.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Side repeater lens defective which has no effect on emitted light outer missing (4.4.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear beam mounts (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Windscreen washer not working (3.5 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Side repeater lens defective which has no effect on emitted light outer missing (4.4.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear beam mounts (5.3.6 (a) (i))

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front Brake pad(s) wearing thin offside (3.5.1g)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Suspension component mounting prescribed area is corroded but not considered excessive both rear beam mounts (2.4.A.3)

Front Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front Brake pad(s) wearing thin offside (3.5.1g)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Suspension component mounting prescribed area is corroded but not considered excessive both rear beam mounts (2.4.A.3)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front exhaust mountings broken

both front tyres and offside rear tyre cracking in tread

Nearside Front Coil spring not correctly located top mount, possible cause (2.4.C.2)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Stop lamp not working (1.2.1b)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front exhaust mountings broken

both front tyres and offside rear tyre cracking in tread

Offside Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)

rear tyres distorted

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)