2008 Toyota Aygo

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Sill damaged

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Suspension arm pin or bush likely to become detached Rear bush (5.3.4 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Sill damaged

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

reduced effort from offside rear foot brake

Front Brake disc worn, pitted or scored, but not seriously weakened n/s and o/s (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened n/s and o/s (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides rear (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear brake has binding

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Reverse sensor wires broken and hanging down

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect bulb fitted wrong (1.8.A.1b)

Tyre tread depth below requirements of 1.6mm both front tyres 1mm (4.1.E.1)

Reverse sensor wires broken and hanging down

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Front Tyre worn close to the legal limit (4.1.E.1)