2003 Fiat Seicento

Front Brake hose slightly deteriorated offside and nearside front brake hoses slightly perished (1.1.12 (b) (ii))

Lower Steering column universal joint has slight wear or play lower steering column universal joint slightly worn (2.2.2 (c))

service brake and parking brake only just met minimum requirements STRONGLY advise brake check

Brake fluid contaminated (1.8 (a))

Exhaust has a major leak of exhaust gases joint after flexi leaking (6.1.2 (a))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Shock absorbers has negligible damping effect (5.3.2 (d))

Front Brake hose slightly deteriorated offside and nearside front brake hoses slightly perished (1.1.12 (b) (ii))

Lower Steering column universal joint has slight wear or play lower steering column universal joint slightly worn (2.2.2 (c))

service brake and parking brake only just met minimum requirements STRONGLY advise brake check

Lower Steering column universal joint has slight wear or play lower steering column universal joint slightly worn (2.2.2 (c))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Coil spring fractured or broken broken (5.3.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Lower Steering column universal joint has slight wear or play lower steering column universal joint slightly worn (2.2.2 (c))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Nail in tyre punctured looks repairable ()

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge 155/65/13 on less than 3mm tread depth (5.2.3 (e))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Oil leak, but not excessive leaking from crank pulley, oil filter, front of sump area (8.4.1 (a) (i))

SERVICE BRAKE efficientcy only 56% minimum is 50% strongly advise brake check

Nearside Front Road wheel fixing missing head of bolt broken off (5.2.1 (a) (i))

Nearside Front Service brake lagging in operation lagging 33% (1.2.1 (d))

Offside Rear Service brake excessively binding handbrake mechainisum siezed (1.2.1 (f))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Oil leak, but not excessive leaking from crank pulley, oil filter, front of sump area (8.4.1 (a) (i))

SERVICE BRAKE efficientcy only 56% minimum is 50% strongly advise brake check

Exhaust has a minor leak of exhaust gases middle section (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear service brake low effort advise check

Exhaust has a minor leak of exhaust gases middle section (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear service brake low effort advise check

O?S rear brake arm partially seized

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

n/s handbrake weaker

spare tyre flat

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Offside Headlamp aim too low (1.8)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)