2006 Land Rover Range Rover

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear suspension components corroded

Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

undersealed

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Under body underseled

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Under body underseled

Offside Front air suspension top mount bearing excessively worn

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced rear floor (6.1.1 (c) (i))

Brake performance unable to be tested (1.2.1 (g))

Brake pipe leaking on a hydraulic braking system front to rear (1.1.11 (b) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced rear floor (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive boot floor area/subframe mount area (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both inner sill areas from front to rear (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

engine management light inoperative

Nearside Front Lower Suspension arm pin or bush excessively worn rear arm (5.3.4 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn front (5.3.4 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn rear (5.3.4 (a) (i))

Nearside Rear Upper Suspension component pin or bush excessively worn rose joint in hub (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Sub-frame pin or bush excessively worn front (5.3.4 (a) (i))

Offside Rear Sub-frame pin or bush excessively worn rear (5.3.4 (a) (i))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear arm (5.3.4 (a) (i))

engine management light inoperative

undertrays fitted preventing full inspection of some components

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Driver's door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Rear Upper Suspension component pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)