2010 Toyota Prius

Suspension component mounting prescribed area is corroded but not considered excessive Axle (5.3.6 (a) (i))

Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Brake lining(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords cut on outer sidewall (4.1.D.1a)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Brake lining(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

o/s/f tyre outer wall slight damage