2001 Volkswagen Beetle

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Inner Steering linkage ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete sill front to rear (6.2.2 (d) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete sill front to rear (6.2.2 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn both (5.1.2 (b) (i))

Rear Brake disc significantly and obviously worn both (1.1.14 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick both (1.1.13 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Brake pipe corroded, covered in grease or other material greased (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)