2005 Toyota Aygo

Front Service brake fluctuating, but not excessively nearside and offside (1.2.1 (e))

Offside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

slight play at nearside and offside front shock absorber insert

Nearside Rear Tyre worn close to legal limit/worn on edge tread worn at edge (5.2.3 (e))

Offside Rear seat belt slow to retract

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear seat belt slow to retract

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Headlamp aim too high both (4.1.2 (a))

Nearside Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps (4.1.3 (b))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

o/s/f tyre heavy edge wear

o/s/r inner wheel arch has accident damage

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear rear brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

o/s/f tyre heavy edge wear

o/s/r inner wheel arch has accident damage

Nearside Rear wheel binding

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear wheel binding

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

slight bind NSR wheel

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Headlamp aim too high (1.8)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

slight bind NSR wheel

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front discs wearing thin

hazard switch requires attention