2004 Mazda MX-5

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting by subframe mount (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting by subframe mount (6.2.2 (d) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Power steering component has slight seepage from a component steering rack (2.1.5 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced chassis section (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced chassis section (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Outer Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced chassis section (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced chassis section (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail (5.3.6 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)