2017 Ktm 125

Chain guard missing ()

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Indicator tell tale missing (4.9.1 (a) (i))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

rear foot rest damaged but operating at this time

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Rear reflector missing (4.8.2 (a) (ii))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Indicator tell tale missing (4.9.1 (a) (i))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

rear foot rest damaged but operating at this time

Abs warning lamp on

Drive chain slightly tight (6.1.7 (k) (i))

Engine warning lamp on

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose Rivets loose (8.1.1 (b) (i))

Gear lever linkage rubs on side stand

Has panels with 390 on

Headlamp bracket hits tank on n/s lock

Ignition switch cable tied on

Side stand bracket bolt missing

Abs warning lamp on

Drive chain slightly tight (6.1.7 (k) (i))

Engine warning lamp on

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose Rivets loose (8.1.1 (b) (i))

Gear lever linkage rubs on side stand

Has panels with 390 on

Headlamp bracket hits tank on n/s lock

Ignition switch cable tied on

Rear reflector missing (4.8.2 (a) (ii))

Side stand bracket bolt missing

Bolts missing from side stand mounting plate allowing bracket to foul gear lever.

Exhaust silencer slightly loose Exhaust rear bracket too flimsy to support silencer assembly. (8.1.1 (b) (i))

Front Brake binding but not excessively (1.2.1 (f))

Gear change lever bent.

Headlight lens lightly tinted .[emitted light not seriously affected].

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Exhaust system insecure Exhaust centre bracket broken off allowing excessive movement of exhaust system. (6.1.2 (a))

Front Wheel excessively distorted front wheel damaged @ bead area causing excessive run out. (5.2.2 (c) (i))

Offside Rear Footrest missing (6.2.12 (a))

Bolts missing from side stand mounting plate allowing bracket to foul gear lever.

Exhaust silencer slightly loose Exhaust rear bracket too flimsy to support silencer assembly. (8.1.1 (b) (i))

Gear change lever bent.

Headlight lens lightly tinted .[emitted light not seriously affected].

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Drive chain worn to excess (6.1.7 (c) (i))

Front Tyre incorrect because a radial tyre is fitted to the front and a cross-ply or bias belted tyre fitted to the rear (5.2.3 (a))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS