2005 Mercedes-benz Vito

Fuel cap very stiff to release indicating sealing rubber may be defective.

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))

Offside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Prop shaft bearing excessively worn (6.1.7 (b) (i))

Prop shaft joint excessively worn (6.1.7 (c) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

center stop light not working

exhaust gas leaking from top of engine

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

center stop light not working

exhaust gas leaking from top of engine

EXHAUST BLOW MANIFOLD AREA FROM COLD + CLAMP BROKEN ON DOWN PIPE (EXHAUST IS SECURE) >>> ATTENSION REQUIRED

Front wheel bearing rough when rotated (2.5.A.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Brake hose slightly deteriorated (3.6.B.4d)

EXHAUST BLOW MANIFOLD AREA FROM COLD + CLAMP BROKEN ON DOWN PIPE (EXHAUST IS SECURE) >>> ATTENSION REQUIRED

Emissions not tested (7.0)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Registration plate lamp not working (1.1.5c)