2007 BMW 530

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Macpherson strut pin or bush worn but not resulting in excessive movement top mount worn (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Macpherson strut pin or bush worn but not resulting in excessive movement top mount worn (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front arm (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front arm (5.3.4 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair

Parking brake lever has little reserve travel

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Parking brake: efficiency below requirements (3.7.B.7)

NEAR SIDE FRONT TYRE INNER EDGE WEARING LOW

Nail in nearside rear tyre

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)