2010 Toyota Auris

general under body corrosion

Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Windscreen washer not working (3.5 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Position lamp light intensity significantly reduced flickering (4.2.3 (a) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm inner tread (5.2.3 (e)) DANGEROUS

rear registration plate deteriorating,oil spill,passenger rear reg light flickering,front-rear brake pipes rusting-underbody components,passenger front tyre tread low,passenger front suspension arm bush splitting

oil leak,rear brake discs rusty,wipers damaged

tyres wearing low on tread

front balljoints wet,oil spill,front discs corroded

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Side repeater not working (1.4.A.2c)

front balljoints wet,oil spill,front discs corroded

Nearside Front Coil spring not correctly located (2.4.C.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

cuts to outer wall nsf tyre not exposing plys