2012 Yamaha Ybr 125

Central Rear Suspension rod pin or bush excessively worn SWING ARM (5.3.4 (a) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Brake grabbing severely (1.2.1 (c))

Rear Brake pedal not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Handlebar grip insecure to handlebar THROTTLE (2.2.1 (d) (ii)) DANGEROUS

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake pedal is short but brake can still be readily applied (1.1.2 (d))

Front Motorcycle structure is fractured but structural rigidity is not significantly reduced MUDGUARD BROKEN (6.1.1 (a) (i))

GEAR SHIFT FOWLING ENGINE CASE

Nearside Lower MISTING OF OIL FROM ENGINE CASE

Rear Tyre worn close to the legal limit (5.2.3 (e))

Registration plate slightly loose (0.1 (a))

Wheel alignment slightly misaligned (2.4 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pedal pivot slightly tight (1.1.1 (a))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Footrest slightly loose (6.2.12 (a))

Brake lever has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Drive chain excessively loose (6.1.7 (c) (i))

Headlamp aim too high (4.1.2 (a))

Nearside Front Footrest insecure (6.2.12 (a))

Rear Brake pedal not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Drive chain sprocket so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Rear Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Brake lever has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Exhaust noisy (7.1.2)

Rear Brake lining(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear suspension bearing has excessive free play (2.4.A2a(i))

Clutch lever bent (6.2.1g)

Clutch lever bent (6.2.1g)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)